15342 Autoloader ALE: Error: request to punch plate when punch not properly installed Trendsetter_400/800_Auto Remove the plate from the machine and select "PLATE CLEARED" button on the workstation dialog box. Call Creo Service. The system wants to punch the plate currently on the unload table, but the rotator and/or punch is not installed in firmware. Check the rotator_installed and punch_installed parameters ("set al ri" and "set al pi"), and the punch_plate parameter for the plate on the unload table ("set state plate_loc u pp"). If plates are to be punched, set the 'al ri' and 'al pi" parameters to 1 and save the new values (nvs save al). If plates are not to be punched, set the media punch_config parameter to 0 (set media n pcfg 0). Any plates using that media type will now be setup to not be punched. It may be useful to set the 'verbose alconv' parameter to 1 in order to obtain further diagnostic information. The punch_plate parameter may be set to 1 with the rotator_installed and/or punch_installed parameters still at 0. ../commands/process.xmlCommand: process ../commands/clear.xmlCommand: clear ../nvs/media_cal_pcfg.xmlNVS: media pcfg Command: set state plate_loc u ../nvs/al_cfg_ri.xmlNVS: al ri ../nvs/al_cfg_pi.xmlNVS: al pi ../nvs/plate_loc_state_pp.xmlNVS: plate_loc pp ../nvs/verbose_cfg_alcmd.xmlNVS: verbose alcmd ../nvs/verbose_cfg_alconv.xmlNVS: verbose alconv ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:33:03 2008 PST